

Geothermal Heating and Cooling--
Using the Earth's temperature for year-round home comfort
Owners of geoexchange systems can relax and enjoy high-quality heating
and cooling year after year. Geoexchange systems work on a different
principle than an ordinary furnace/air conditioning system, and they
require little maintenance or attention from homeowners. Furnaces must
create heat by burning a fuel--typically natural gas, propane, or fuel
oil. With geoexchange systems, there's no need to create heat, hence no
need for chemical combustion. Instead, the Earth's natural heat is
collected in winter through a series of pipes, called a loop, installed
below the surface of the ground or submersed in a pond or lake. Fluid
circulating in the loop carries this heat to the home. An indoor
geoexchange system then uses electrically-driven compressors and heat
exchangers in a vapor compression cycle--the same principle employed in
a refrigerator--to concentrate the Earth's energy and release it inside
the home at a higher temperature. In typical systems, duct fans
distribute the heat to various rooms.
In summer, the process is reversed in order to cool the home. Excess
heat is drawn from the home, expelled to the loop, and absorbed by the
Earth. Geoexchange systems provide cooling in the same way that a
refrigerator keeps its contents cool--by drawing heat from the
interior, not by injecting cold air.
Geoexchange systems do the work that ordinarily requires two
appliances, a furnace and an air conditioner. They can be located
indoors because there's no need to exchange heat with the outdoor air.
They're so quiet homeowners don't even realize they're on. They are
also compact. Typically, they are installed in a basement or attic, and
some are small enough to fit atop a closet shelf. The indoor location
also means the equipment is protected from mechanical breakdowns that
could result from exposure to harsh weather.
Geoexchange works differently than conventional heat pumps that use the
outdoor air as their heat source or heat sink. Geoexchange systems
don't have to work as hard (which means they use less energy) because
they draw heat from a source whose temperature is moderate. The
temperature of the ground or groundwater a few feet beneath the Earth's
surface remains relatively constant throughout the year, even though
the outdoor air temperature may fluctuate greatly with the change of
seasons. At a depth of approximately six feet, for example, the
temperature of soil in most of the world's regions remains stable
between 45° F and 70° F.This is why well water drawn from below ground
tastes so cool even on the hottest summer days.
In winter, it's much easier to capture heat from the soil at a
moderate 50° F. than from the atmosphere when the air temperature is
below zero.This is also why geoexchange systems encounter no difficulty
blowing comfortably warm air through a home's ventilation system, even
when the outdoor air temperature is extremely cold. Conversely, in
summer, the relatively cool ground absorbs a home's waste heat more
readily than the warm outdoor air.
Studies show that approximately 70 percent of the energy used in a
geoexchange heating and cooling system is renewable energy from the
ground.The remainder is clean, electrical energy which is employed to
concentrate heat and transport it from one location to another. In
winter, the ground soaks up solar energy and provides a barrier to cold
air. In summer, the ground heats up more slowly than the outside air.
Back to technologies!
For more information please contact Future Green Chatham project.
© 2007 Martin Purnell and Associates LLC
Site maintained by Partnering Solutions
|